The Sabre Standard 28 degree baseplate is a rear-specific, low angle geometry, designed to work in tandem with our 48 degree baseplate to produce a split angle system on any longboard.
Here at Sabre we have built a complete longboard truck system – everything works with everything else. You can use this baseplate and pivot cup with every Sabre longboard hanger ever made, going right back to 2008.
The 28 degree pivot angle is very slack compared to most longboard trucks. This means that it leans a lot more and turns a bit less than a “regular” longboard truck, which usually have a pivot angle of 40-50 degrees.
If you already have a set of Sabre trucks, you can buy one of these to convert your board into a “split angle” setup, which has a lot of benefits:
- Easier to Pump
- Carves with more lean, closer to the feeling of a snowboard or surfboard
- More agile at slow speeds
- More stable at high speeds
If you are converting an existing Sabre setup to a split angle system, you also need to:
- Change your bushings on the front truck to be softer than you would usually run, and adjust the truck so it turns as much as possible
- Run a harder bushing on the rear truck than you normally would, to create a solid platform for pumping and carving
- Check your board for wheelbite before you skate. You might need to run an extra riser or switch to a slightly smaller wheel.
Like all our longboard baseplates, the 48 comes drilled “double old school”. It’ll work with a shorter “new school” drill pattern, but if you are running “old school,” you can benefit from a little bit of wheelbase adjustment.
We use a solid grade 8 steel, splined and pressed in kingpin.
The baseplate is Low Pressure Die Cast (LPDC or “Liquid forged”) from A356 Aluminium, and heat treated to a T6 standard.
Ships complete with a Sabre Pivot Cup and a kingpin nut.
